Products: Stainless Steel Flexible Connector - Bulletin

STAINLESS STEEL FLEXIBLE HOSE AND EXPANSION JOINTS

Mason Industries was started in 1958. Our first effort went toward the creation of a totally new approach to Vibration Isolation using high deflection free standing springs as opposed to traditional inadequate methods. Our more recent work includes new approaches to both seismic and bomb blast protection, architectural isolation for floating floors, walls and ceilings, and complete building isolation, always using our own designs or new methods

more...

STAINLESS STEEL AND BRONZE BRAIDED HOSE

60 years ago (when the writer started), braided stainless steel hose had been in use for quite some time. As I remember, there were only a few major manufacturers. such as Chicago Metal Hose and Anaconda. For the most part, the smaller assemblers did not invest in the expensive equipment that forms straight tubing into the helical and annular forms, and certainly not in the complex braiding equipment. Thus the standards in the industry were maintained by the major firms. While helical hose (corrugations in a continuous helix) was still...

more...

STAINLESS STEEL AND BRONZE BRAIDED VEE

A vertical loop has always been a very useful and popular hose configuration and is still used in small diameters. If the radius is generous and considerably larger than the minimum bend radius. (i.e.: Hose forced into an arc less than the minimum bend radius takes a permanent set.) The configuration can move in many interesting ways as sketched. The degree of motion is dependent on the diameter, length of free hose and the radius. Hoses that are more flexible because of more corrugations per foot, will accept greater displacements...

more...

STAINLESS STEEL AND BRONZE VEE TEST DATA

We are pleased to provide you with this essential test data on the stiffness of Vees in all directions. Theory and design have their place, but testing tells the true story and should be the basis of application whenever possible. Our Bulletin BH-29 did the job for straight hoses and proved the inadequacy of short lengths. Vees are much more complex. They move in all modes and it takes different forces to move them In and Out, Up and Down or Transverse. We built our own test equipment to cover this broad range of sizes from 1/2” through 12” with proper force and movement calibration. These test reports supplement Product Bulletin VH-30.

more...

EXPANSION COMPENSATORS AND HOUSED EXPANSION JOINTS

We are all interested in product development, but it is often difficult to trace. Let us share what we have learned. When applying internally pressurized expansion joints, the designer has to be concerned with extension, compression, angular and torsional motion. Like automobile tires, rubber expansion joints are thick skinned forgiving creatures that tolerate abuse. Stainless steel is very reliable too, but only if expertly designed, properly anchored and guided. All of us have taken a strip of metal and bent it back and forth until it cracked and snapped. Multiple corrugations designed to low stresses elimiate the problem.

more...

ADJUSTABLE SLIDING GUIDE

All of us have gotten accustomed to using Spider Pipe Guides because they have been around forever. In looking for a better way, we found the following areas for improvement:

1) There is no single Spider Guide for any pipe size. The ID is standard, but the length of the guide fins and the ID of the housing all vary with insulation thickness. There can be as many as five selections for the same diameter pipe.

This makes stocking difficult and the contractor cannot buy without knowing the insulation thickness.

2) While they are used in other positions, most Spider Guide have no allowable load ratings as they are single purpose Guides.

more...